What’s that? you set a password on the PXE Service Point, and now you cannot unset it?
Never fear folks for I have the solution:
- Open up the PXE Service Point properties and make sure the General Tab is active
- Delete the password from the two boxes
- Then remove the tick from the “Require a Password for computers to boot using PXE” box
- Click Apply then OK
Why its not just a case of removing the tick, I don’t know (If you do and dont delete the password – the password is re-enabled when you click OK…
I bet you, you’re kicking yourselves now aren’t you?
I know I was….
Comments